Enter Edid Firmware Mode; Setup Procedure (Vga & Hdmi 1) - Acer H6500 Service Manual

6-3 Enter EDID Firmware mode

1. Hold on the "Power" button, then plug in the power
cord.
2. When the "Power LED" flashes blue, release the
"power" button.
3. When the "Power LED" flash Blue-->Blue-->Red
alternates, it means the projector has got into EDID
Firmware mode.
6-4 Setup Procedure
����� ��� HD�I 1� ����� ��� HD�I 1�
1. Connect all ports
(1) Connect P1 of fixture to COM Port of PC/Laptop
by RS232 Cable.
(2) Connect P2 of fixture to VGA IN Port of projector
by VGA Cable.
(3) Connect P3 of fixture to HDMI1 Port of
projector by DVI Cable and "HDMI(M) To
DVI(F) Adapter". .
(4) Plug Power Adapter to P4 of fixture.
(5) Plug Power Cord to projector.
Note: - You must confirm that the JP3 is closed in
all procedure.
��dapter
P4
RS232 Cable
P1
JP3
���� IN Port
D�I
Power
Cable
Cable
H6500 Confidential
D�I Cable
P3
���� Cable
P2
HD�I��� To
D�I�F� ��dapter
6-3