LEAP PCFACE-PCIE1-2.0 USER MANUAL CONTENTS ● INTRODUCTION OF LEAP ELECTROINC PCFACE-PCIE1-2.0 ..........● DESCRIPTION OF PANEL INDICATION ....● DESCRIPTION OF FEATURES AND SPECIFICATIONS ..........● INSTALLATION AND OPERATION PROCEDURES ............● DOS TEST PROCEDURES & WINDOWS TEST WARNING ............. ●...
Page 3
Leap Electronic has been dedicated to developing and manufacturing PC Interface Extension Protector for many years and we are the leading supplier of PC Interface Extension Protector. Leap Electronics' PCFACE series, which are the most cutting edge and efficient solutions, include the...
LEAP PCFACE-PCIE1-2.0 USER MANUAL DESCRIPTION OF PANEL INDICATION 1. PCFACE-PCIE1-2.0 board: 2. DESCRIPTIONS: (1) CON2:Slot ×1。 Extensible PCI-Express ×1 slot. A variety of of testing cards can be overlapped on the slot. Capable of being overlapped the extended protection slot x1, MPCIE and Express Card, which belong to consumables and should be replaced by users if necessary.
LEAP PCFACE-PCIE1-2.0 USER MANUAL DESCRIPTION OF FEATURES AND SPECIFICATIONS 1. FEATURES (1) Extend the PCI-Express slot on PC motherboard to protect PC against the damage causing the DUT failure or short circuit. (2) The hot swap function: efficiently enhancing the performance, save the booting time without turning the PC off when you want to change to next DUT (Notes: turning PCFACE-PCIE1-2.0 power off is requested.) (3) Protect over current or short circuit of the external power.
Page 6
LEAP PCFACE-PCIE1-2.0 USER MANUAL INSTALLATION AND PROCEDURES 1. FIRST TIME INSTALLATION: Exchanging the interface card without turning off the PC is outstandingly featured on PCFACE-PCIE1. Insert the PCI-Express card to the PC and then install the DUT driver enabling the new DUT to be identified by the PC. Please follow the installation steps as follows: ※...
LEAP PCFACE-PCIE1-2.0 USER MANUAL PCFACE-PCIE1-2.0 FLOW CHART OF INSTALLATION AND OPERATION START Turn off PC power Install PCIE1 protector card Lock steadily PCIE1 interface card Change different ID card testing loop Plug in external DUT Turn on PC power Change the same ID card testing loop Install the Setup DUT driver...
Page 8
LEAP PCFACE-PCIE1-2.0 USER MANUAL 2. OPERATION PROCEDURES: DOS AND WINDOWS A. DOS: 1. Turn off the PC. 2. Insert the DUT to PCFACE-PCIE1 slot and fix it with brackets. 3. Turn on the PC and power up PCFACE-PCIE1. Must boot by DOS instead of the DOS supported under Windows. In the CD: root director “PCI-EXPRESS”-->...
LEAP PCFACE-PCIE1-2.0 USER MANUAL UN-INSTALL, REMOVE AND MAINTENANCE 1. When removing PCFACE-PCIE1 primary card, turning off the PC power is requested preventing from unexpected damages. Note: Unexpected damages failure may occur if the DUT is removed without turning off PCFACE-PCIE1 power which is exclusive of our guarantee under the artificial operation.
LEAP PCFACE-PCIE1-2.0 USER MANUAL DESCRIPTION OF OPTIONAL ACCESSORIE OF EXTENSION CARD 1. The extension testing card is optional according to the PC case. Please purchase through Leap's distributors or related sales representative and service department. 2. Picture of the accessory : (this picture is for reference only)