Program Configurations - ABB COMMANDER 1900 Series User Manual

• Ramp/Soak
...2 CONTROL CONFIGURATION LEVEL
2.1.1 Program Configurations – Fig. 2.3
There are 99 segments that can be shared between programs and control channels. For normal applications it is recommended
that segments 1 to 50 are assigned to channel 1 and segments 51 to 99 are assigned to channel 2. Fig. 2.3 shows 9 segments,
shared between four separate programs on channel 1 and channel 2.
Seg. 1 Seg. 2
2.1.2 Soak Adjust – Fig. 2.4
The Soak Adjust function allows the Soak time of a segment to be extended or reduced by a value preset in the
in the
Ramp/Soak Profile Control Page
panel of the instrument or by a digital signal .
Displays show the
Time Remaining
SEG 8
t 30. 0
0 30 60
Initial 60-minute Soak Time.
Lower display shows
time remaining.
4
Seg. 3 Seg. 4 Seg. 5
Program 1.01
Program 1.02
Program 2.01
Fig. 2.3 Program Configurations
. The soak time can be adjusted repeatedly while the segment is running, either from the front
frame in the
Operating Page, OPERATOR LEVEL
t 35. 0
Flashing
E 5. 0
0 30
Soak Time extended by
5 minutes to 65 minutes.
35 minutes remaining.
Fig. 2.4 Example of Soak Adjust
Seg. 6 Seg. 7
Program 2.02
t 40. 0
Flashing
E 10. 0
65 0 30
Soak Time extended a further
5 minutes to 70 minutes.
40 minutes remaining.
Seg. 8 Seg. 9
Soak Adjust
x3
t
Flashing
E
70 0
Soak Time reduced by
15 minutes to 55 minutes,
5 minutes less than the
initial Soak Time
frame
35. 0
-5. 0
30 55