Table of Contents
Advertisement
Controlling the FlashSystem unit:
Powering on/off
Uptading firmware
Configuring network settings
Changing storage mode (JBOF or RAID 0)
Creating logical volumes (LUNs)
Configuring LUN masking
Configuring host interfaces
Configuring user security
Setting the date and time
Supported platforms
IBM FlashSystem systems support a wide range of operating systems (Windows Server 2003 and 2008,
Linux, and IBM AIX®), hardware platforms (IBM System x
from IBM), HBAs, and SAN fabrics. For specific information, see the System Storage Interoperation
Center (SSIC):
http://ibm.com/systems/support/storage/ssic
Physical and electrical specifications
FlashSystem 710 and FlashSystem 810 have the following physical, electrical, and environmental
specifications:
Dimensions and weight (approximate):
Height: 44 mm (1.7 in.)
Width: 432 mm (17.0 in)
Depth: 569 mm (22.4 in)
Weight: 13.6 kg (30 lb)
Operating environment:
Temperature:
Operating: 10 - 35 degrees C (50 - 95 degrees F) at 30.5 m below to 3000 m above sea level
(100 ft below to 9,840 ft above sea level)
Non-operating: -10 - 50 degrees C (14 - 125 degrees F)
Humidity:
Operating: 20% - 80%
Non-operating: 10% - 90%
Supported electrical input:
100 - 240 (nominal) V ac; 50-60 Hz
Input electrical power (approximately):
FlashSystem 710: 280 watts
FlashSystem 810: 350 watts
BTU output:
FlashSystem 710: 955 BTU/hr
FlashSystem 810: 1194 BTU/hr
Acoustical:
Noise emission: 8.0 bels
IBM FlashSystem 710 and IBM FlashSystem 810
, IBM Power Systems, and x86 servers not
®
12
Advertisement
Table of Contents
