Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Trionic Veloped 12er M
Summary of Contents for Trionic Veloped 12er M
- Page 1 English...
- Page 2 Veloped both off-road and in the city. The Veloped is primarily made for outdoor use. By choosing a Trionic Veloped you will enjoy a whole range of benefits, and it will improve your access to different outdoor environments and hopefully increase your quality of life.
- Page 3 Trionic Veloped The Veloped has a unique 3-wheel design, but as you can see it has in fact four wheels. It’s aimed to be used as a walking aid, especially for people with the desire to be physically active out- doors.
-
Page 4: Technical Data
The Product Technical Data 12er M 12er L 14er M 14er L Min. height: 75 cm 82 cm 77 cm 84 cm Max. height: 95 cm 102 cm 97 cm 104 cm Width: 76 cm 79 cm 76 cm 79 cm Length: 102 cm 102 cm... - Page 5 Safety Veloped Seat & Basket • Both brakes should be locked in par- Seat cover king mode before you use the seat. • Before you start walking with the Velo- The seat cover is made of water-repellent and resistant 600D polyester fabric. It is easily ped, make sure it’s completely unfolded.
-
Page 6: First Time Use
First Time Use 1. Attach the rear wheels to the 2. Check that the wheels are axle and press the axle into 5. Adjust the height of the han- frame’s rear axle holes by press- properly attached by pulling/ the axel hole from underneath. dlebar as described in Chapter ing the black button in the cen- pushing them sideways. - Page 7 Walking Mode 1. Unfold the Veloped by pull- 2. Check that the Veloped 3. The seat can be slid forward ing the gripbar handles side- locks in walking mode; when and rearward. Push it forward ways, away from each other. unfolding it make sure you to obtain maximum walking hear a click from the telescopic...
- Page 8 Folding the Veloped 1. Pull the seat to the rear. 3. Simultaneously lift and fold 4. Press the other button on 5. Simultaneously lift and fold one frame half against the the left of the telescopic stay. one frame half against the 2.
-
Page 9: Parking Brake
Motion Brake Parking Brake Option 3: Use both hands. Pull To operate the motion brake, You can engage the parking Option 2: Pull the upper red par- the upper red parking trigger pull the brake lever upwards. brake in 3 different ways. king trigger rearwards with your rearwards with one hand, while Brake with both levers at the... - Page 10 Gripbar Adjustment NOTE: The easiest way to 1. Release both quick-release 3. Lock both quick-release NOTE! Do not operate the adjust the gripbar is when sit- levers by folding them out- levers by folding them inwards. quick-release levers like wing ting on the seat;...
- Page 11 Grip Angle Adjustment The angle of the grips can be 2. Turn/rotate the grip to your 3. Tighten the screw on the rear adjusted so that you get a com- chosen angle. end of the grip with a 4 mm allen fortable hand position and an key.
-
Page 12: Brake Adjustment
(counter- ing your Trionic Veloped, if the the Veloped. wheel axle into the axle hole. clockwise) and lock it in posi- brakes still works poorly. -
Page 13: Removing/Installing The Front Wheel
Check the tire air pressure reg- removable to simplify trans- suspension, lift the frames axle into the axle hole placed ularly. Trionic recommends a portation of the Veloped. front end from the surface under the frame. Release the 1.5 – 2.0 bar tire pressure. - Page 14 Change Front Wheel Setting: City mode/Off-road mode There is an adjustment handle Upper position: 1. Grab the left wheel with 3. Slide the adjustor (right on the front wheel, placed in your left hand and lift the Vel- hand) either downwards or Offers increased climb- the between the wheels, that ing capacity, suspension on...
- Page 15 Removing/Attaching the Basket The basket of the Trionic 1. Wrap the rear velcro flaps 2. Attach the front velcro flap 3. If necessary, adjust the Veloped has a 22-litre load- around the rails from under- in the same manner. velcro sections to ensure that ing capacity.
-
Page 16: Removing/Installing The Seat
2. Attach the three front push 4. Finally, press the three last comprised of a seat base and text Trionic to the right. Wrap buttons of the long flap to the push buttons of the long flap a removable cover fixed with the long flap between the teles- seat base. -
Page 17: Safety Instructions
• If your Veloped is not in perfect condition: please immedia- • Do not use the Trionic Veloped as a wheel chair or for trans- tely contact your retailer/dealer or service representative porting people. authorized to service your Trionic Veloped. - Page 18 Tel.: +46 8 522 100 50, Fax.: 08-522 100 59 Max. User Weight Max Weight: 150 kg guarantee is valid from the date of purchase, and covers Trionic the international Width Width: 76 cm original parts only.
-
Page 19: Troubleshooting
Environmentally Friendly Troubleshooting The Trionic Veloped is manufactured in the way to have as little If your Trionic Veloped does not work satisfactory, you can negative impact on the environment as possible during its lifecy- check it by following the troubleshooting guide below. If the cle. - Page 20 Trionic Sverige AB Seminariegatan 29 C SE-752 28 Uppsala SWEDEN www.trionic.biz info@trionic.se Telephone: +46 8 522 100 50 Fax: +46 8 522 100 59 Corp.ID: 556698-1527 . VAT Reg. No SE556698152701...
Need help?
Do you have a question about the Veloped 12er M and is the answer not in the manual?
Questions and answers