Nilfisk-Advance SC100 Operating Manuallines

ATTENTION! Do not use the machine before you have read and understood the Instructions for use manual.
1. Release the handle to remove the 2. Fill the solution tank with a clean
tank assembly.
6. Use the orange pedal to put the 7. When machine is in working
machine in working position.
11. The red LED blinks when the 12. To use the manual suction hose press
machine is getting low on solution
and fixed light when empty. Empty
the recovery and refill the solution
tank to continue working.
16. Check and clean the solution and
17. Remove the squeegee bars.
vacuum filter regularly.
(*) ALWAYS FOLLOW THE DETERGENT DOSING RECOMMENDATION ON THE LABEL OF THE CHEMICAL PRODUCT USED.
(**) THE MANUAL SUCTION HOSE IS INCLUDED ACCESSORY ONLY FOR THE FULL PACKAGE VERSION; FOR THE BASIC VERSION IS AN OPTION.
ScrubVac
Nilfisk A/S Tel.: +45 43 23 40 50
01309 676796
Banemarksvej 58, Fax: +45 43 43 77 00
sales@scrubvac.co.uk
DK-2605 Broendby mail.com@nilfisk.com
www.scrubvac.co.uk
DENMARK www.nilfisk.com
3. The tank cap can be used for
water. The clean water temperature dosing the detergent. One full cap
must not exceed 40 °C. is 30ml giving 1% detergent of the
3L tank capacity. (*)
8. Press one of the solution buttons,
position press the main button according to the type of cleaning to
and start cleaning. Machine will be performed:
automatically stop when parked 1 drop - normal cleaning
upright. 2 drop - heavy duty cleaning
At the end of the work
13. Park the machine in upright
the main button to start the machine in
upright position. Turn the hose connec-
tion to ON and use the suction tube.
When done press the main button and
turn hose connection to OFF. (**)
18. Unscrew by turning the knob
OPERATING GUIDELINES
SC100
4. Connect the power plug to the
electrical socket.
9. Move the machine with the handle
and start cleaning the floor.
Click
14. Disconnect the power plug from
position. the electrical socket and rewind
If needed turn off the machine by the cable from the machine and
pressing the main button. place it in the cable holder.
Press the main switch to "0".
19. Clean the squeegee bars and the
cylindrical brush with water.
clockwise to remove the
cylindrical brush.
5. Turn on the machine with the main
switch to "I".
10. For double scrubbing, use the
pedal to lift/lower squeegees.
15. Empty the recovery and solution
tank. Clean them with water.
20. Clean the machine using a damp
cloth and where needed use a
neutral cleaning product. Then
store the machine in a clean and
dry place.