LENCO MPR-033 Instruction Manual page 3

Getting Started
Before using your Radio for FM, fully extend the FM TELESCOPIC ANTENNA and position for
the best reception.
Before connecting the power, check that the mains voltage on the rating plate of the AC/DC
adaptor is same as the voltage in your area.
 Plug the DC cord from the AC/DC adaptor into the DC jack on the side of the unit.
 Plug the AC/DC adaptor into the wall socket and switch the mains power on.
Battery Operation
1. Remove the Battery Compartment Cover by gently pushing the clips downward and outwards.
2. Install 4 x 'AA' size batteries (UM-3 or equivalent) and take care that the correct polarities are
observed.
3. Replace the battery compartment cover.
NOTE:
 The DC cord must be removed for battery operation.
 To avoid damage which may result from leaking batteries, remove the batteries when they
become exhausted or when the unit is not to be used for a long period of time.
NOTE: If there's no audio signal input to the unit in about one hour, the unit will enter to power off
mode automatically.
FM RADIO
TUNING THE FM RADIO
1. Press the STANDBY button on the front of the unit to power on the unit.
2. Switch to the FM radio mode by pressing the MODE button on the front of the unit repeatedly.
3. Press the SKIP/SEARCH FORWARD or SKIP/SEARCH BACKWARD button on the front of
the unit to fine tune radio station. Press and hold the SKIP/SEARCH FORWARD or
SKIP/SEARCH BACKWARD button to auto search radio station forward or backward
respectively (When an available station is found, the unit will broadcast it immediately and the
searching will be stopped).
4. Press the VOL+/- button on the front of the unit to adjust the volume level.
5. Press the STANDBY button to turn off the unit.
STORING YOUR FAVORITE RADIO STATION (UP TO 6 PRESET STATIONS)
1. Tune to your favorite radio station first.
2. Press and hold one of the NUMERIC buttons (1~6) to store the radio station on the
corresponding memory cell (the "S-1"~"S-6" displays on the screen).
3. To store other stations, follow the above steps.
4. During radio playback, short press the corresponding numeric button to recall the preset
station.
USB/SD CARD PLAYBACK
1. Press the STANDBY button on the front of the unit.
2. Insert an USB or a SD card into the USB port or SD card slot on the right side of the unit.
3. Press the MODE button repeatedly to switch to USB or card mode. The playback will start
automatically.
4. Press the VOL+/- button to adjust the volume level.
5. Press the SKIP/SEARCH FORWARD or SKIP/SEARCH BACKWARD button on the front of
the unit to skip to the next/previous track.
6. Press and hold the SKIP/SEARCH FORWARD or SKIP/SEARCH BACKWARD button to
search through the track forward or backward.
7. Press the REPEAT button on the front of the unit once to repeat play the current track; press
GB-2