Raymarine STV Gen2 Installation And Operation Manual page 32

Setting the DiSEqC method
We recommend that you do NOT attempt to change the DiSEqC.
However, if you have to do so, contact the Raymarine Customer
Support Department for advice before making any changes.
1. Carry out the Enter setup mode procedure to display the SET
SAT PAIR? screen.
2. Press the NEXT soft key five times to display the USE DISEQC?
screen.
3. Press YES to display the DiSEqC edit screen.
4. Use the PREV or NEXT soft keys to select the required DiSEqC
method. The options are:
• USE TO CHANGE BAND - DiSEqC used to change high and
low bands.
• USE TO CHANGE SAT - DiSEqC used to change the satellite
being tracked.
• DO NOT USE DISEQC - DiSEqC not used.
5. Press the ENTER soft key to accept the frequency value and
display the SAVE? screen.
6. Press, either:
• The YES soft key to save the changes you have made, or
• The NO soft key to discard any changes.
The SETUP MODE? entry screen is then displayed.
7. Press either:
• YES if you want to use another setup function, or
• NO to re-initialize the system using the new settings.
Manually directing the antenna
You can use the ACU to manually control the antenna. The options
are:
• Setting the antenna go position - you set horizontal and vertical
angles to which you want the antenna to point.
36
• Antenna move step - enables you to manually step the antenna,
to the required horizontal and vertical directions.
Setting antenna go position
1. Carry out the Enter setup mode procedure to display the SET
SAT PAIR? screen.
2. Press the PREV soft key five times to display the ANT GO
POSITION? screen.
3. Press YES to display the GO TO AZ edit screen.
4. Define the horizontal position to which you want the antenna to
move, as follows:
i. Use the + and - soft keys to change the value of the character
above the cursor (underscore).
ii. Press the INPUT soft key to accept each correct character
and move the cursor to the next character.
iii. Repeat sub-steps a, b and c until the required value has
been entered.
5. Press the ENTER soft key to confirm the horizontal position and
display the GO TO EL edit screen.
6. Using a procedure similar to that in steps 4 and 5, define the
vertical position to which you want the antenna to move.
7. Press the ENTER soft key to confirm the vertical position and
display the GOTO POSITION? screen.
8. Press:
• YES to drive the antenna to the position you have set. When
you no longer need the antenna to point in this direction, press
the EXIT soft key to return to the SETUP MODE? screen.
• NO to return to the ANT GO POSITION? screen.
Setting antenna move step
1. Carry out the Enter setup mode procedure to display the SET
SAT PAIR? screen.
2. Press the PREV soft key four times to display the ANT MOVE
STEP? screen.
STV Gen2 installation and operation