Introduction; Getting Started - Raymarine STV Gen2 Installation And Operation Manual

3.1 Introduction

This section of the handbook describes how to set up your
Raymarine Satellite TV system after installation using the ACU or the
Graphical User Interface (GUI), and includes the following functions:
• System start up
• Change the default satellite
• Monitor the antenna status
• Enter set up mode
• Setting your operating region
• Setting the default satellites
• Setting up Remote Control
• Setting the GPS
Many of the above functions will only be required at initial installation
of your system.
Important: Raymarine does not recommend changing the
satellite information unless advised to do so by the satellite
provider.
Note: The satellite names shown on the ACU screen are
dependent on geographic location and therefore may be different
to the names in this manual.
Note: Vertical and horizontal polarization applies to regions with
linear polarization only
28
• Editing satellite information
• Setting antenna parameters
• Setting the local frequency
• Setting the DiSEqC method
• Display versions
• Setting antenna go position
• Setting antenna move step

3.2 Getting started

Switching on
Ensure your IRDs and television monitors are switched on.
Press the power switch on the ACU to switch on the system. Check
on the ACU that the start-up screens are displayed in the correct
sequence.
Startup sequence
Start of communication between antenna and the
INITIALIZE ACU
RAYMARINE 45 S
Antenna initialized.
INITIALIZE ANT
RAYMARINE 45 S
Antenna is searching for Satellite
SEARCH A: ASTRA2
HOTBIRD
SETUP
Operating mode - antenna tracking satellite
TRACKING A:
ASTRA2
B:HOTBIRD SETUP
TRACKING A: ASTRA2
B:HOTBIRD TURKSAT
ACU.
TV
ENNA
TV
A.
System set with two
default satellites
System set with three
default satellites
STV Gen2 installation and operation