Setup Using The Acu - Raymarine STV Gen2 Installation And Operation Manual

3.3 Setup using the ACU

Setup principles
Using the ACU
The ACU setup mode gives access to a series of setup pages, to
enable you to adjust the system parameters.
When setting up the system from the ACU, three context-dependent
soft keys below the display are used to select and adjust the
required parameters.
SET SAT PAIR?
NEXT
PREV YES
Single function soft keys are used only during setup routines:
• The BACK soft key enables you go to the previous screen.
• The ENTER soft key is used to confirm settings.
You can:
• Define a pair or trio of satellites you want to use.
• Set the system to work with GPS.
• Edit a range of satellite information.
• Set various antenna parameters.
• Set the LNB local frequency.
• Set the DiSEqC method.
• Reset the system to factory default values.
You can also use setup mode to manually control the direction that
the antenna points.
30
BACK
ENTER
Setup routines
In setup mode, use the PREV or NEXT soft key to select the
required setup screen.
For some setup functions, you also use the PREV and NEXT soft
key to select a particular value. For example, when setting default
satellites, you use PREV or NEXT cycle through the names of
available satellites.
Editing screens
Some setup screens enable you to edit individual characters and
are typically presented in this manner:
SAT NAME: ASTR A2
- INPUT
+
On the screen, the editable character is indicated by an underscore
cursor (under A in this illustration).
To edit the characters:
1. With the cursor under the first character, use the - and/or + soft
keys to move through the available characters until the required
character is displayed above the cursor.
2. Press the INPUT soft key to accept the edited character. The
cursor then moves to the next character.
3. Repeat steps 1 and 2 until you have edited all necessary
characters. If you want to change any character, use the BACK
soft key to move the cursor to the relevant character.
4. When you have completed the edit for a screen, press the
ENTER soft key to accept the values and move to the next setup
screen.
Entering setup mode
Enter setup mode as follows:
BACK
ENTER
STV Gen2 installation and operation