TP-Link WBS210 Installation Manual page 6

English
3
Position the Base Station and wrap
the metal strap around the pole.
Feed the end back through the
screw-block and turn the screw
clockwise to tighten the metal strap
using a flathead screwdriver until
the Base Station is secure.
4
Connect the RF cables from the Base Station to the corresponding
connectors on the antenna.
Power On
Connect the Base Station to a Power over Ethernet (PoE) adapter as
follows:
1
Connect the Ethernet cable from the Base Station to the PoE port
of the PoE adapter.
2
Connect an Ethernet cable from your LAN device (a computer,
router or switch) to the LAN port on the PoE adapter.
3
Connect the power cord to the power port on the PoE adapter
and plug it into an electrical outlet.
4