For Standing Pilot Models With; Robertshaw Gas Valve, 2-Stage; To Turn Off Gas To The Boiler (Models 90, 135 & 180); For Automatic Ignition Models - Raypak 0180B Type H Installation And Operating Instructions Manual

For Standing Pilot Models with

Robertshaw Gas Valve,
2-stage Operation
(Models 90, 135 & 180)
1. STOP! Read the safety information.
2. Set the thermostat to the lowest setting.
3. Turn off all electrical power to the boiler.
4. Push in and move gas control lever counter-
clockwise
GAS CONTROL
LEVER SHOWN
IN "OFF" POSITION
GAS INLET
Fig. 27: Gas Valve
NOTE: Lever cannot be moved from "ON" to "OFF"
unless lever is pushed in slightly. Do not force.
5. Wait five (5) minutes to clear out any gas. Then
smell for gas, including near the floor. If you smell
gas, STOP! Follow "B" in the safety information on
the label affixed to the unit. If you don't smell gas, go
to the next step.
6. Locate pilot mounted on the right side of the
burner tray, and right of first burner.
HONEYWELL PILOT
Fig. 28: Pilots
7. Move control lever clockwise
position and immediately light pilot with a match.
8. Hold lever in "SET" position for 1/2 minute after
pilot is lit. Release lever, and it will spring back
to "PILOT" position. Pilot should remain lit. If it
goes out, repeat steps 4 through 8.
to "OFF" position.
ROBERTSHAW PILOT
to "SET"
*If lever does not spring back to "PILOT" position
when released, stop and immediately call your
service technician or gas supplier.
*If the pilot does not stay lit after several tries,
move the gas control lever to "OFF" and call your
service technician or gas supplier.
9. Stand to the side of the boiler and move the gas
control lever counter-clockwise
10. Turn on all electrical power to the boiler.
11. Set the thermostat to the desired setting.
To Turn Off Gas to the Boiler
(Models 90, 135 & 180)
1. Set the thermostat to the lowest setting.
2. Turn off all electrical power to the boiler
3. Push in and move gas control lever counter-
clockwise

For Automatic Ignition Models

Please read carefully and understand the following
safety information before operating the boiler.
WARNING: If you do not follow these instructions
exactly, a fire or explosion may result causing
property damage, personal injury or loss of life.
A. This boiler is equipped with an ignition device
which automatically lights the pilot. Do not try to
light the pilot by hand; or this boiler may not have
a pilot and is equipped with a hot surface ignition
device which automatically lights the burners. Do
not try to light the burners by hand.
B. BEFORE OPERATING smell all around the boiler
area for gas. Be sure to smell next to the floor
because some gases are heavier than air and will
settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch.
• Do not use any phone in your building.
• Immediately call your gas supplier from a neigh-
bor's phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in, move or turn the
gas control knob or lever. Never use tools. If the
knob or lever will not push in, move or turn by
hand don't try to repair it, call a qualified service
28
to "ON".
to "OFF" position. Do not force.