Cisco ASA 5506-X Quick Start Manual page 5

Cisco Firepower Threat Defense for the ASA 5506-X Series Using Firepower Device Manager Quick Start Guide
Connect the Interfaces
The default configuration assumes that certain interfaces are used for the inside and outside networks. Initial
configuration will be easier to complete if you connect network cables to the interfaces based on these
expectations. To cable the above scenario on the ASA 5506-X series, see the following illustrations.
Note: The following illustrations show a simple topology using a management computer connected to the inside
network. Other topologies can be used and your deployment will vary depending on your basic logical network
connectivity, ports, addressing, and configuration requirements.
Version 6.2
Figure 5 ASA 5506W-X (with Wi-Fi), 5506-X (without Wi-Fi) for Version 6.2.
GigabitEthernet 1/1
outside, DHCP from Modem
Status
Power
12VDC, 5A
Internet
WAN Modem
Figure 6 ASA 5506H-X for Version 6.2.
GigabitEthernet 1/1
outside, DHCP from Modem
Power
12VDC, 5A
Internet
WAN Modem
GigabitEthernet 1/2-1/8 Bridge Group
inside, 192.168.1.1
wLAN
Active
S L S L S L S L S L S
Power
1 2 3 4 5
Management Computer
DHCP from inside: 192.168.1.x
GigabitEthernet 1/2-1/4 Bridge Group
inside, 192.168.1.1
1 3
2 4
Management Computer
DHCP from inside: 192.168.1.x
4. Deploy the Firepower Threat Defense in Your Network
S L
GE MGMT
L S L S L
USB
6 7 8 CONSOLE
S L
GE MGMT
USB
RESET
CONSOLE
5
Wifi: See
quick start guide
RESET