Table of Contents
Advertisement
3
TOUCH SETUP
3
In this section you will setup the Touch device and plug in the cables.
WHAT'S INCLUDED
Included in the box:
•
Touch 3D stylus
•
Power cord
•
Power supply
•
USB cable
•
Quick Start Guide
CONNECT THE TOUCH
1.
Carefully remove the
Touch
2.
Position the Touch device in your workspace, using both hands to grasp the base of the device.
NOTE: See
"Handling the Touch Device" on page 9
damage.
3.
Insert the smaller end of the
your computer.
power cord
4.
Plug the
into the
3D Systems, Inc.
and
cables
from the box.
for instructions on how to handle the device to reduce the risk of
USB cable
into the Touch device, then connect the larger end of the USB cable into the USB port on
power
supply.
6
Advertisement
Table of Contents
