RIDGID DMG9015 Operator's Manual page 12

APPLICATION
9. Lower the gauge bar into the table-saw-blade assembly
opening and allow the magnets to attach to the blade.
Always position the magnetic blade attachment close to
the center of the blade to keep the gauge bar from con-
tacting the lower guard. Do not tighten the locking handle
(Fig. 20 and 21).
NOTE:
Be careful not to place the magnets near or on the saw blade
teeth.
10. Set the blade tilt angle by using your table saw controls
to adjust the blade to the desired angle, as indicated in
the miter-gauge display. If desired, flip the display by
briefly pressing the Power button again.
Fig.20
NOTE:
In the process of moving the blade, ensure that the magnets
are always attached to the blade. If the magnets separate
from the blade, an inaccurate setting will result.
11. Remove the miter gauge and replace the table-saw in-
sert according to the table saw's instruction manual be-
fore beginning to cut.
Fig.21
12