Table of Contents
Advertisement
Bowers Flybaby
5) When you are sure that everything is
aligned correctly, mix up a generous
amount of Flash 30 Minute Epoxy. Ap-
ply a thin layer to the mounting slot
and to bottom of the vertical stabilizer
mounting area. Apply epoxy to the bot-
tom and top edges of the filler block and
to the lower hinge also. Set the stabilizer
in place and realign. Double check all of
your measurements once more before
the epoxy cures. Hold the stabilizer in
place with T-pins or masking tape and
remove any excess epoxy using a paper
towel and rubbing alcohol. Allow the
epoxy to fully cure before proceeding.
Hinge.
ELEVATOR PUSHROD
INSTALLATION.
22
C/A glue.
Elevator control horn.
1) Thread one clevis and M2 lock nut on
to the elevator control rod. Thread the
clevis on until it is flush with the end of
the control rod.
2) Elevator pushrod assembly as pictures
below.
M2 clevis.
Fuel tubing.
Hex nut.
M2 lock nut.
8mm
Elevator pushrod.
.
Pen.
M2 clevis.
Advertisement
Table of Contents
