Advertisement
Wall Bracket Assembly
1
Install the angle adjustment bracket on the wall as
shown in the figure.
3
2
1
4
Tighten the angle adjustment bracket by using anchors
and screwsⓐ orderly from ① to ⑦. (Turn the rotating part
of the bracket to the right or left to install the bracket more
easily.)
If it cannot be installed on the assigned area, install at the
nearest place.
C heck the solidity of the wall before the installation. Strengthen the wall and install the bracket if the wall is
not firm enough.
The supplied screws and anchors are for installing on concrete walls.
For the wall of plaster, marble, or steel, use the appropriate screws.
2
Remove the screws on the product. Tighten the 4 screwsⓑ on the back panel by using the assembling tool.
Be sure that 5 mm of each screw is left to be unscrewed.
(About 5 mm space is required to hang on the angle adjustment bracket.)
LFD
※ When installing the LFD, assemble the LFD using the holder-ring injection mold supplied with the LFD.
M ount the product on the wall bracket. Be sure to check on the left and right side to see if it is properly fixed.
Be careful when installing the product or adjusting the angle as fingers can be caught in the holes.
Be sure the wall bracket is securely fixed to the wall. Falling down the product may cause physical damage.
WMN4070SD-eng-wall mount.indd 2
How to Tighten Anchors or Screwsⓐ
5
6
7
※ Use the drill with the required size when making a
hole in the wall.
Be sure to follow the directions for the installation
to avoid safety problems.
Supplied
Holder-Ring
Make a hole in the wall with the drill
of 6X50. (WMN-2370 : 5X40)
Clean up the hole.
Insert the supplied anchor to the hole.
Match the angle adjustment bracket
to the holes on the wall and tighten
the screwsⓐ.
2011-06-22
6:04:18
Advertisement
