Monogram ZDOD240 Owner's Manual page 10

Loading
tips and
suggestions
The bottom full extension drawers pull out so
Removing
bottles can conveniently be added or removed.
full extension
The upper full extension slide can be removed
drawers
for magnums or larger bottles.
To remove:
1. Pull the full extension drawer out to the
2. Push the tab on right drawer guide down
To replace:
1. Push the drawer slide arm back into the
2. Pull the small slide sub-assembly
3. Insert the sides of the drawer back into the
4. Push until the tabs lock into place.
Wood
The full extension drawer fronts on the outdoor/
indoor refrigerator are unfinished cherry wood.
drawer
During use, oil from hands may accumulate
fronts
and stain the wood.
• The drawer fronts may be stained and sealed
10
The bottom two full extension drawers hold
five bottles each and are loaded with necks
facing the rear. Tall bottles should not be
loaded on the bottom drawer because they
may prevent the door from closing.
• Do not block the thermistor, located on the
right-hand side, just above the third shelf of
the outdoor/indoor refrigerator. Blocking the
thermistor could impair the air circulation and
temperature control.
STOP position.
while pulling the tab on left guide up, and
pull the drawer out.
unit.
completely forward.
guides.
to match adjacent cabinetry.
Controls and Features
Outdoor/Indoor Refrigerator
Bottom drawer arrangement
Appearance may vary
Sub-assembly
To replace, push drawer
slide arm back into unit
NOTE: Make sure the tabs on the full
extension drawer guides are fully engaged
before loading any bottles. Pull the drawers
out all the way to the STOP position and push
back in several times to make sure locking tabs
are properly engaged.
• Apply the stain and sealer according to
the manufacturer's instructions. To avoid
unpleasant odor, keep the door open to
ventilate and allow the stain/sealer to dry
completely before using the product.
NOTE: Natural wood may vary slightly in grain
and color.
Tab (push tab down on
right drawer guide, pull tab
up on left drawer guide)
Sub-assembly
Pull small slide sub-assembly
completely forward