Advertisement
FWM-49
o
4
2
3
1
WM-208 Features
o
Setting: ID
1. After starting up, press and hold
2. LCD displays "1234" (factory setting value)
first figure flashes
press
then press
and then press
until finished adjusting all four figures
then press
setting is complete
3. 2 seconds after the setting is complete, it will
automatically restart, and the setting of the new ID
value is complete
WM-209 Features
Uses a single directional, ultra-sensitive capacitive microphone head
Capacitive microphone head sensitivity: (0db=1v/pa 1khz)/frequency
response: 50HZ~16KHZ
Lavalier microphone head accessory, male /female collar clip can be freely
worn on either the left side or right side; guaranteed quality will never
fracture.
Gain size level: The sensitivity gain size level can be manually adjusted at
anytime while in use.
Appearance design, lightweight and novel, innovative design; unique
patented design of battery magnetic body.
Automatic Search Setting
1. Simultaneously press
powering up
2. Then power up
Manual Setting
1. Simultaneously press
powering up
2. Then power up
3. For manual setting, press and hold
shows CH-01 value, then press
down
VOL volume adjustment:
VOL mode while using)
UHF frequency band/fully digitalized CMOS technology processing
Uses Japan Sanyo 3.7v-2100mA rechargeable lithium battery
When activating the microphone and receiver for initial use, first set the grouping
LCD display code
Any product from our company can be interchangeably-grouped easily, and is
not limited to group use
9999 band group selection settings, no external signal interference
When turned on, the microphone (WM-208/WM-208K) will first automatically
scan for a suitable environmental position, and then the receiver will also follow
and use the suitable frequency band selected by the microphone for use
Uses single directional microphone head: Pattern: Hyper Cardioid
Microphone head sensitivity -49db (0db=1v/pa 1khz)/frequency response:
50HZ~14KHZ
Gain size level: The sensitivity gain size level can be manually adjusted at
anytime while in use
Microphone head and body used multiple noise anti-vibration processing
to adjust the value
to set the next figure (flashes)
to adjust the value and so on
to return to the first figure and
and
before
the displayer shows CH-ON (automatic search)
and
before
the displayer shows CH-OF (manual setting)
for two seconds
and
to adjust the value up or
VOL (-)/
for two seconds
displayer
VOL (+) (both in
Advertisement
