Wireless Microphone - Wireless Receiving Features; Wireless Transmission Audio Function Operations; Transmitter Id Code Setting; Host Id Number Location - Sanha jlh-202d User Manual

3
Wireless Microphone – Wireless Reception Features
Supports 48KHz' 16 bit 2 channel uncompressed audio frequency transmission.
After powering on, it will automatically scan the surrounding environment and
select an uninterrupted frequency for use.
The volume is controlled by digital units, low power consumption.
There are two reception systems equipped in the receiver: Diversity A and B;
they both receive the wireless microphone's signal through individual antennas.
It compares the signal strength on both A and B, and selects the better signal as
the output.
Receiver frequency response 20Hz-20kHz/+-0db Receiver sensitivity -90db.
9999 band group selection settings; absolutely will not be interfered by external
signals.

Wireless Transmission Audio Function Operations

1. Wireless transmitter (Wm-209) input jack 3.5mm aperture transmission cable connection.
Audio (IPOD/IPHONE-MP3 player) can be played back wirelessly.
2. Wireless transmitter (Wm-209) can control the volume directly (start up value set as 30).
3. Wireless transmitter (Wm-209) can be used with (FWM-49) lapel microphones.

Transmitter ID Code Setting:

When using this unit for the first time,
setting sequence method:
ID code,
Open the back cover of the JLH-202 unit and insert the power cord, turn on the
power switch located on the side of the main unit and then at the back cover...
under the rechargeable battery there is the wireless receiver's 4 digit ID code.
(Ex: 9999)
Then...turn on the power of the WM-209 wireless transmitter, then press and hold
down the (-) button for approximately 2 seconds, the LCD screen will display 4
digits/(Ex: 1234) set to the same ID code as the main host.
※ Please refer to the

Host ID number location:

1. Inside the main unit on the receiver board (inside the main unit)
2. At the back cover of the main unit where the battery is placed (the battery
must be removed)
3. At the bottom of the unit body
UHF WIRELESS
TRANSMITTER
VOLUME
Connect to WM-209
wireless transmitter input jack
o
3.5 MONO jack
ID setting procedure
Wireless transmission connection description
Factory default value: 1234)
(
please first set the WM-209 wireless transmitter's
to the right for detailed settings.
marked at 3 locations with labels
Connect to audio output
o
3.5 STEREO jack