Table of Contents
Advertisement
Disassembly and Reassembly of the Nail Feeder Section
[Tools required]
• Hex. bar wrench (5 mm )
• Roll pin puller (ø 4, ø 2)
• C-shaped snap ring puller for hole
Body Ass'y [39]
Piston Bumper [41]
O-Ring (S-38) [42]
O-Ring (1AP-3) [102]
Nose [43]
Change Knob [44]
Lock Spring [45]
Steel Ball D3.175 [46]
Needle Roller [47]
Roll Pin D4 x 18 [48]
Feeder Arm (B) [49]
Feeder Spring [50]
Feeder (A) [51]
Nylock High Tension
Bolt M6 x 20 [52]
Pushing Lever
Cover (A) [54]
Pushing Lever (A) [55]
Retaining Ring For D24 Hole [110]
Feed Piston Cover [109]
Feed Piston [105]
Feed Piston O-Ring (I.D. 14) [104]
O-Ring (P-9) [103]
Hex. Socket Hd.
Bolt M5 x 20 [111]
Spring [114]
Nose
Piece [116]
Shaft Ring [112]
Nose Shaft [115]
-28-
Bumper [108]
Feed Spring (B) [107]
Feed Spring (A) [106]
Pushing Lever Spring [72]
Pushing Lever (C) [73]
Adjuster [74]
Roll Pin D2 x 16 [77]
Adjuster Spring [81]
Adjuster Plate (C) [82]
Adjuster Plate (A) [83]
O-Ring (S-4) [84]
Pushing Lever (B) [85]
O-Ring (S-5) [86]
Retaining Ring (E-Type)
For D3 Shaft [87]
Advertisement
Table of Contents
