Figure 8.2 Service Tasks, Radius Base - Industrial Scientific Radius BZ1 Product Manual

Align the screw holes and
place the new boot on the
base.

Figure 8.2 Service tasks, Radius Base

Power off the instrument before disassembling or performing any service task.
Module removal
Use the supplied screwdriver set to loosen the two locking
screws on the back of the SafeCore Module. The screws are
captive and will not separate completely from the Module.
Module disassembly
Turn the module upside
down to access the cover.
Using the screwdriver set,
remove the six screws; set
them aside for later
reassembly.
Replace and tighten the
screws. Refer to Table 8.1 for
torque value.
—
Hold the cover by the edges.
Lift the cover to remove it.
If the cover is to be replaced,
dispose of the used cover
according to company policy;
otherwise, set it aside for
later reassembly.
84
—
To remove the module from
its port, pull it straight away
from the base. Use care not
to damage the module's
connector pins.
Hold the sensor collar by
the edges. Lift it straight up
to remove it; set aside the
collar for later reassembly.