AMX NX-1200 Webconsole And Programming Manual page 22
Nx-series controllers, enova dvx all-in-one presentation / digital media switchers, massio controlpads
Hide thumbs
Also See for NX-1200:
- Hardware reference manual (42 pages) ,
- Hardware reference manual (43 pages) ,
- Hardware reference manual (48 pages)
Table of Contents
Advertisement
3.
Click Get IP Information to enable the fields for editing (FIG. 9):
Network Addresses dialog showing initial IP information
FIG. 9
4.
Enter the System, Device (0 for NetLinx Masters), and Host Name information.
NOTE: Host names may contain only the ASCII letters 'a' through 'z' (in a case-insensitive manner), the digits '0' through '9', and the
hyphen ('-').
5.
To configure a network address via DHCP (FIG. 10):
Network Addresses dialog (DHCP)
FIG. 10
Select Use DHCP.
a.
Click Set IP Information to retain the DHCP setting.
b.
To finish the process, click Reboot Device.
c.
Click Done to close the dialog.
d.
6.
To specify a network IP address (FIG. 11):
Network Addresses dialog (Specify IP Address)
FIG. 11
Select Specify IP Address.
a.
Enter the IP parameters into the available fields.
b.
Click Set IP Information to retain the pre-reserved IP address to the Master.
c.
To finish the process, click Reboot Device.
d.
Click OK to close the dialog.
e.
NX-Series Controllers - WebConsole & Programming Guide
Initial Configuration
22
Hide quick links:
Advertisement
Table of Contents
