Contents 1 Important Safety Notice 2 Your clock radio Introduction What's in the box Overview of the main unit 3 Get started Connect power Set clock 4 Listen to radio Tune to a radio station Adjust the volume level 5 Set the alarm timer Set the alarm time Turn on the alarm timer View the alarm time...
1 Important Warning • Never remove the casing of this apparatus. • Never lubricate any part of this apparatus. • Never place this apparatus on other electrical equipment. • Keep this apparatus away from direct sunlight, naked Safety flames or heat. • Never look into the laser beam inside this apparatus.
Page 5
Class II equipment symbol This symbol indicates that the unit has a double insulation system. Environmental information All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet.) Your system consists of materials which can be recycled and reused if disassembled by...
2 Your clock radio Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With this clock radio, you can: • listen to FM radio. • know the time. • wake up to buzzer alarm or radio •...
Overview of the main unit c SLEEP a TUNING • Set the sleep timer. • Tune to a radio station. b REPEAT ALARM/SLEEP OFF • Adjust the time of clock, alarm timer • Repeat the alarm. and sleep timer. • Disable the sleep timer.
Page 8
e AL1, AL2 • RADIO: Set the current radio station as the alarm source. • BUZ: Set the buzzer as the alarm source. • OFF: Turn off the alarm timer. f VOL • Adjust the volume level of radio. g Display panel h AL RESET • Stop the alarm.
3 Get started Caution • Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in sequence. Connect power Caution • Risk of product damage! Ensure that the power supply voltage corresponds to the voltage printed on the back or the underside of the apparatus.
4 Listen to radio Tune to a radio station Press RADIO ON/OFF to turn on the radio. Adjust TUNING slowly to tune to a radio station. • To turn off the radio, press RADIO ON/OFF again. Adjust the volume level Rotate VOL clockwise or anti-clockwise.
5 Set the alarm Repeat alarm timer When the alarm rings, press REPEAT • ALARM/SLEEP OFF. » The alarm repeats ringing 9 minutes later. Set the alarm time Stop alarm ring You can set two separate alarms. For the alarm When the alarm rings, press AL RESET.
6 Other features Set the sleep timer You can set the clock radio to turn off automatically after a certain period of time (0 to 59 minutes). Note • Before the setup, ensure Clock Control is switched to CLOCK and the radio is turned off. Press and hold SLEEP.
7 Product information Note • Product information is subject to change without prior notice. Specifications Tuner (FM) Tuning Range 87.5 - 108 Sensitivity - Mono, 26dB S/N Ratio < 22 dBf Total Harmonic Distortion < 3% Signal to Noise Ratio >...
If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www. philips.com/support). When you contact Philips, ensure that your apparatus is nearby and the model number and serial number are available.
Need help?
Do you have a question about the AJ1050 and is the answer not in the manual?
Questions and answers