Philips AJ100/12 User Manual

Philips AJ100/12 User Manual

Philips clock radio aj100
Hide thumbs Also See for AJ100/12:


Clock Radio
User manual


Table of Contents

Summary of Contents for Philips AJ100/12

  • Page 1 Clock Radio AJ100 User manual...
  • Page 4 SUPPLIED ACCESSORIES – 1 X AC 7.5V adapter (Input: 220-230V ~ 50Hz 30mA, Output: 7.5V TOP AND FRONT PANEL (See 1 ) 1 REPEAT ALARM / BRIGHTNESS CONTROL – switches off the alarm for a 9 minute period – changes the brightness of the display illumination –...
  • Page 5: Power Supply

    SIDE PANEL (See 1 ) – 8 TUNING +/- tunes to radio stations – 9 Pigtail improves FM reception – 0 DC 7.5V socket for AC/DC 7.5V adapter ! SET AL / PRESET 1 @ SET AL / PRESET 2 –...
  • Page 6: Basic Features

    SELF-POWERED BACK-UP The self-powered back-up conveniently allows your preset stations, alarm and clock time settings to be stored for up to 3 minutes when there is a power interruption e.g. AC power failure. The complete clock radio and backlight illumination will be switched off.
  • Page 7: Automatic Tuning

    RADIO 1 Press RADIO ON/OFF once to switch on the radio. ™ Display shows the radio frequency of the last selected waveband briefly before returning to the clock time. Your preset station is also shown if you are listening to a preset. (See 2 ) 2 Adjust the sound using VOLUME.
  • Page 8: Using The Alarm

    USING THE ALARM GENERAL Two different alarm times can be set. This can be useful when you need to be woken up at a different time e.g. during the week and at the weekend: • ALARM - radio mode • ALARM - buzzer mode.
  • Page 9: Switching Off The Alarm

    SWITCHING OFF THE ALARM There are three ways of switching off the alarm. Unless you cancel the alarm completely, the 24-hour ALARM RESET will be automatically selected after 59 minutes from the time your alarm first goes off. 24 HOUR ALARM RESET If you want the alarm mode to be stopped immediately but also wish to retain the same alarm setting for the following day: •...
  • Page 10: Enviromental Information

    SLEEP (See 4 ) About Sleep This set has a built-in sleep timer, which enables the radio to be automatically switched off after a set period of time. There are four sleep time options. Setting and switching off SLEEP 1 Within 1 second, press ALARM RESET / SLEEP twice until the display shows SLEEP and SL: 60.
  • Page 11: Maintenance And Safety

    MAINTENANCE & SAFETY • Install the unit near the AC outlet and where the AC power plug can be easily reached. • The apparatus shall not be exposed to dripping or splashing. • Do not expose the set to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight.
  • Page 12: Troubleshooting

    TROUBLESHOOTING If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee.
  • Page 13 CAUTION - Visible and invisible laser radiation. If the cover is open, do not look at the beam. - High voltage! Do not open.You run the risk of getting an electric shock. The machine does not contain any user-serviceable parts. - Modification of the product could result in hazardous radiation of EMC or other unsafe operation.
  • Page 14: Clock Radio

    Clock radio Meet Philips at the Internet English Printed in China PDCC-JH-AZ-0645...

This manual is also suitable for:


Table of Contents