Philips AJ1003 User Manual

Philips AJ1003 User Manual

Philips clock radio user manual
Hide thumbs Also See for AJ1003:


Register your product and get support at
User manual


Table of Contents

Summary of Contents for Philips AJ1003

  • Page 1 Register your product and get support at AJ1003 User manual...
  • Page 2 Important Safety Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with dry cloth. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. Do not install near any heat sources such as radiators, heat UHJLVWHUV VWRYHV RU RWKHU DSSDUDWXV LQFOXGLQJ DPSOLÀHUV that produce heat.
  • Page 3 apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. Battery usage CAUTION – To prevent battery leakage which may result in bodily injury, property damage, or damage to the unit: ‡ Install the battery correctly. ‡...
  • Page 4 This product complies with the radio interference requirements of the European Community. $Q\ FKDQJHV RU PRGLÀFDWLRQV PDGH WR WKLV GHYLFH WKDW DUH QRW expressly approved by Philips Consumer Lifestyle may void the user’s authority to operate the equipment. Your product is designed and manufactured with high quality materials and components, which can be recycled and reused.
  • Page 5: Your Clock Radio

    Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment. Your clock radio Congratulations on your purchase, and welcome to Philips! To fully EHQHÀW IURP WKH VXSSRUW WKDW 3KLOLSV RIIHUV UHJLVWHU \RXU SURGXFW DW Introduction With this clock radio, you can: ‡...
  • Page 6: Overview Of The Main Unit

    Overview of the main unit + TUNING - ‡ Tune to a radio station.
  • Page 7 REPEAT ALARM/BRIGHTNESS CONTROL ‡ Repeat the alarm. ‡ Adjust the brightness of display panel. AL1, AL2 ‡ Enable/disable the alarm timer. ‡ Activate the alarm time setup. / SOURCE ‡ Turn on or off the unit. ‡ Switch between FM radio play, MP3 link input, and clock time display.
  • Page 8: Get Started

    Get started Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the bottom of the apparatus. Write the numbers here: Model No.
  • Page 9 To replace the battery:...
  • Page 10: Connect Power

    Open the battery compartment. Insert one lithium CR2025 battery with correct polarity (+/-) as indicated. Close the battery compartment. Connect power Caution ‡ Risk of product damage! Ensure that the power supply voltage corresponds to the voltage printed on the back or the underside of the apparatus.
  • Page 11: Set Time And Date

    Connect the power adapter to ‡ the DC IN (DC 5V) jack on the back of the main unit. ‡ the power socket. Set time and date In clock mode, press and hold SET TIME/PROG for 2 seconds. Press PRESET +/PRESET -. »...
  • Page 12: Listen To Radio

    Repeat steps 2-3 to set the minute. Repeat steps 2-3 to set the year. Repeat steps 2-3 to set the month. Repeat steps 2-3 to set the day. View the preset date Press DATE repeatedly. » The clock time, month, day and year are displayed consequently.
  • Page 13: Program Radio Stations Manually

    Press SOURCE repeatedly to turn on the radio. Press and hold SET TIME/PROG for 2 seconds. » All available stations are programmed in the order of waveband reception strength. » 7KH ÀUVW SURJUDPHG UDGLR VWDWLRQ EURDGFDVWV DXWRPDWLFDOO\ Program radio stations manually Note ‡...
  • Page 14: Set The Alarm Timer

    Select a preset radio station Press SOURCE repeatedly to turn on radio. Press PRESET +/PRESET - to select a radio station. Set the alarm timer Set the alarm time You can set two separate alarms. Note ‡ Before you start, ensure that the clock time is set correctly. Press and hold AL1 (or AL2) for 2 seconds.
  • Page 15 Turn on/off the alarm timer Note ‡ Ensure that you already set the alarms successfully. Press AL1 or AL2 twice. » If the alarm timer is turned on, » If the alarm timer is turned off, View the alarm settings Press AL1/AL2.
  • Page 16: Other Features

    Other features Set the sleep timer You can set the radio to turn off automatically after a certain period of time. Press SLEEP repeatedly to select a preset period of time. » appears. » The volume decreases gradually in the last 5 minutes. To turn off the sleep timer: Press SLEEP repeatedly until »...
  • Page 17: Product Information

    Product information Note ‡ Product information is subject to change without prior notice. 6SHFLÀFDWLRQV 7XQHU )0 Tuning Range Sensitivity - Mono, 26dB S/N Ratio Search Selectivity Total Harmonic Distortion Signal to Noise Ratio General information AC Power Operation Power Consumption Dimensions - Main Unit (W x H x D) Weight...
  • Page 18: Troubleshooting

    If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site ( When you contact Philips, ensure that your apparatus is nearby and the model number and serial number are available. No power ‡...
  • Page 19 Clock/timer setting erased ‡ Replace the battery. ‡ Power has been interrupted or the power plug has been disconnected. ‡ Reset the clock/timer.
  • Page 20 © 2012 Koninklijke Philips Electronics N.V. All rights reserved. AJ1003_12_UM_V3....

This manual is also suitable for:


Table of Contents