Rangemaster 110 DUAL FUEL U109600-02 User Manual page 36

Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
15. To Change Oven Door Outer Panel
Remove the two plastic blanking plugs from the door
handles. Remove the 4mm Hex headed screws holding the
handle to the door with the hexagon key tool. Remove two
screws from top edge and two from bottom edge of the
door.
Remove outer door panel. Fit door handle to new panel. Fit
the plastic blanking plugs to the fixing holes.
The handles should be above the fixings.
Fit panel to door. If replacing the outer panel on the right
hand door (with the Thermodial) take care to make sure the
sensor of the Thermodial is sealed to the door by the rubber
grommet.
������
ArtNo.320-0029 - Thermodial
Reassemble in reverse order.
16. To Change Oven Door Catch
Remove outer door panel
(see 15). Remove screws 'B'
holding catch assembly to
inner door panel. Fit new
catch and reassemble in
reverse order.
Check correct door
operation.
SERVICING - WARNING
17. To Adjust Oven Door Catch Keep
18. To Change Oven Door Seal
19. To Change Ignition Generator
������
�������
20. To Remove Oven Inner Back.
36
Open oven door, slacken off locknut at base of keep, and
screw in or out as required until required fit is obtained.
Retighten locking nut.
Open oven door. The seal is held in place by small hooks on
the rear face. At the corner pull seal diagonally away from
the door centre until that hook is released. Proceed to the
next hook and release it in a similar way, and so on.
When fitting new seal, position the seal join at the bottom.
Hook the new seal in one of the corner holes of the door,
and proceed round the door snapping in each hook in turn.
Disconnect from electricity supply.
Pull cooker forward to gain access to the cover box at the
rear of the left hand cooker. Remove the screws securing
the cover and lift clear. Pull off all the leads to the generator
noting their positions. Slacken the two screws holding
generator to cooker and remove generator.
Fit new generator to cooker and replace leads. Reassemble
in reverse order. Refer to wiring diagram. Check ignition
performance.
Open the oven door. Remove oven furniture. For the left
hand oven unscrew the 2 thermostat phial fixing screws.