Toshiba B-SX6T Series Option Installation Manual page 6

Hide thumbs Also See for B-SX6T Series:

INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT

Connect the cutter harness to the connector on the printer through the opening of the main frame.

10. Mount the cutter cover with the two screws.

Fit the cutter cover into the cutter attaching screws and secure the cutter cover with the two screws.

Cutter Cover

11. Attach the operation panel and the left side cover on the printer.

12. Close the top cover and right side cover.

13. After the reassembly is completed, perform a test print to confirm that the cutter works properly.

If the print start position becomes misaligned when media is fed in the reverse direction, fine adjust

the back feed value using the Back Feed Fine Adjustment procedure in system mode.

Connector

Screw

1- 4

1. Cutter Module: B-SX208-QM-R

Main Flame

Opening

Cutter Harness

Screw

Cutter Attaching

Screw

EO15-33002

Table of Contents

B-sx8t series