Hyundai J3 Shop Manual page 131

FL-78
*
Notice
When tightening the nut, ensure that the connector
remains aligned with the injector row axis (Figure
13).
[Fig.13]
injector connector
-1?-JII-'rl--+-+---
injector row axis
CFLOFL033
- Tighten the nut on the rail side to a torque of 40
Nm(29.5 Ib-ft) (Figure 14).
[Fig.14]
- Reassembly all the items removed to
assist access.
ESSENTIAL
CFLOFL034
To vaJidate the repair, start the engine and check
the tightness of the HP connection.
FUEL SYSTEM
Removal of rail/pump pipe
- Remove all the items liable to restrict access:
- Remove the air intake housing
- Remove the mounting bracket of the air/air heat
exchanger situated next to the rail/pump HP pipe
(Figure 15).
[Fig.15]
Mounting
bracket
CFLOFL021
- Clean the HP connections with a solvent
(CARCLEAN type) applied with a clean brush
(Figures 16 and 17).
- Vacuum the particles with a 'BLOVAC BV11' type
pneumatic suction device (Figures 18 and 19).
[Fig.16]
CFLOFL035