Installation Of Indoor Unit - Lennox LI012CI-230P432 Owner's Manual

Installation of indoor unit

Step one: choosing installation location
Step two: install wall-mounting frame
1. Hang the wall-mounting frame on the wall; adjust it in horizontal position with the
plastic expansion particles in the holes.
3. Fix the wall-mounting frame on the wall with tapping screws (ST4.2X25TA) and
Step three: open piping hole
1. Choose the position of piping hole according to the direction of outlet pipe. The
position of piping hole should be a little lower than the wall-mounted frame,
shown as below.
、12K:
Wall
Mark in the middle of it
Space
to the
wall
above
Left
Rear piping hole
24K:
Wall
Mark in the middle of it
Space
to the
wall
above
Left
Rear piping hole
position. In order to drain smoothly, slant the piping hole on the wall slightly
18K:
Wall
Wall
Level meter
Space
Space
to the
wall
above
above
Left
Right
Rear piping hole
Rear piping hole
Wall
Level meter
Space
to the
wall
above
Right
Rear piping hole
25
rm it with the client.
Mark in the middle of it Level meter
to the
wall
.
Wall
Space
to the
wall
above
Right
Rear piping hole