Battery Installation; Battery Notice - VTech Go! Go! Smart Wheels Push & Discover Police Car User Manual

BATTERY INSTALLATION

1. Make sure the unit is turned OFF.
2. locate the battery cover on the bottom
of the unit. Use a screwdriver to loosen
the screw.
3. install 2 new AA (AM-3/lr6) batteries
following the diagram inside the
battery box. (The use of new batteries
i s r e c o m m e n d e d f o r m a x i m u m
performance.)
4. replace the battery cover and tighten the
screw to secure.

BATTERY NOTICE

• Use new alkaline batteries or fully charged NI-MH (Nickel Metal-
hydride) rechargeable batteries for best performance.
• Use only batteries of the same or equivalent type as recommended.
• Do not mix different types of batteries: alkaline, standard (carbon-
zinc) or rechargeable (ni-Cd, ni-Mh), or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in fire.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging (if
removable).
• Rechargeable batteries are only to be charged under adult
supervision.
5