Table of Contents
Advertisement
Replacing
Burn, Electrical
Shock and Fire Hazard
l
Make sure all surface
units are OFF before
replacing
surface
units and
reflector
bowls.
Failure to do so can result in burns or electrical
shock.
l
Do not line the reflector
bowls with foil. Fire or electrical
shock
could
result.
1.
Turn off all surface units.
2. Line up openings
in the reflector
bowl with the surface unit recep-
tacle and the element
hold down
clip
3. Hold the surface
unit as level as
possible
with the terminal
just
started
into the receptacle.
Push
the surface
unit terminal
into the
receptacle.
4. When terminal
is pushed
into the
receptacle
as far as it will go, push
down the edge
of the surface
unit
opposite
the receptacle.
The ele-
ment hold down clip will keep the
surface unit from moving
around.
NOTE: Reflector
bowls reflect
heat back
to the utensils
on the surface
units. They also help catch
spills. When they are kept clean,
they
reflect
heat better
and look new longer.
If a reflector
bowl gets discolored,
some of the utensils
may not be
flat enough,
or some may be too large for the surface
unit. In either
case, some of the heat that's meant
to go into or around
a utensil
goes down and heats me reflector
bowl. This extra heat can discolor
it. See Cooking
Guide
for further
information.
17
Advertisement
Table of Contents
