Partex Moca Quick Start Manual page 3

Adjusting the Card thickness
•
Adjust the card thickness using the green wheel inside the input hopper.
1. Open the printing module compartment cover
2. Rotate the green wheel until the arrow points to the thickness of the card to be
printed.
3. Close the printing module compartment cover.
Partex PFC cards, recommended settings
Recommended settings for card thickness, 0.76
PFC 04212
PFC 04215
PFC 04218
PFC 04221
PFC 04230
PFC 09540
PFC 09580
PFC 09518
PFC 07533
Recommended settings for card thickness, 0.5
PFC 45080
PFC 07014
PFC 12726
In Matica Printer Manager choose "output hooper" under Preferences -> Card.
See instructions under "Set printing settings" in this manual.
Quick Start Moca
Recommendation, see below.
Recommendation, see below.
Recommendation, see below.
Recommendation, see below.
Recommendation, see below.
Recommendation, see below.
Partex Marking System