If You Have Problems; Manual Code Search - Radio Shack 3-in-One Pocket Remote Owner's Manual

15-1930.fm Page 10 Monday, July 19, 1999 1:09 PM

IF YOU HAVE PROBLEMS

MANUAL CODE SEARCH

If the 3-in-One Pocket Remote Control does not op-
erate your remote-controlled devices when you first
set it up, you might have to manually find the correct
code for your devices. You can try all the codes listed
in "Manufacturers' Codes" on Page 12 for the brand
of your device, or you can follow these steps to
search the remote control's entire library.
1. Manually turn on the device you want to set up.
2. Press the corresponding device key (
).
CBL
3. Hold down until the red light blinks twice, then
P
press three times. The red light blinks
CH
twice again.
4. Aim the remote control at the device you want to
operate.
5. Repeatedly press
the device until it responds to the command.
6. When the device responds to the command,
press within 5 seconds to save the code.
P
Note: If you do not press
the remote control does not save the code.
• Because the remote control's library has so
many codes, this procedure can take several
minutes.
• If your device turns off during the search, but
does not operate after you lock in the code,
begin the search again, pausing longer
between key presses.
If necessary, repeat these steps for each device.
Need help? Call 1-888-533-7135
10
Need help? Call 1-888-533-7135
10
,
TV VCR
then the device key for
PWR
within 5 seconds,
P
, or