Installing The Probler P2 On Equipment Other Than Glascraft - Glas Craft Probler P2 User Manual

Installing P on Equipment other
than GlasCraft
WARNING
Do not place any part of the body in the path of the
material spray.
Do not point the gun at or near other personnel.
Do not look into the mixing chamber orifice at any time.
Because of the hazardous materials used in this
equipment, it is recommended that the operator use an
air mask, goggles, protective clothing, and other
safety equipment as prescribed by current regulations,
recommendations of the chemical suppliers, and the
laws in the area where the equipment is being used.
If original equipment does not require the use of an un-
heated whip hose or isolation hose, the P2 can be
directly installed on to the material hose.
.
Remove the fittings from the original gun, typically
these fittings are 1/8 in. NPT male.
.
Remove GCI fittings, p/n's 8560-23,PG-13 from
PG-15-01 ball valves. GCI ball valves are 1/8 in.
NPT female.
Installation
3.
Install the original fittings into PG-15-01 valves.
NOTE
It is recommended to use a non-permanent thread lock on
the 1/8 in. NPT threads to assist as a sealant and keep the
fittings from twisting with gun movement.
4.
Install the gun on the original Hoses.
The air slide valve, p/n 16832-00 is a ¼ in. NPSM.
WARNING
Relieve ALL system fluid and air pressures according to
manufacturer's instructions.
4