Day/Night Switch (Day/Night Only); Connections; Dditional Djustments; Dd Level ( For Dc- Type Lenses ) - GE Interlogix KTC-511P Installation Instructions And Owner's Manuals

1.1.6 D /N
AY IGHT
When the AUTO/MANUAL switch is set to manual, the camera can be switched manually from
daytime colour mode to nighttime B/W mode.
2 C
ONNECTIONS
See Figure 7 and perform the following:
To power
supply
Figure 7. Back panel connections
Attach the monitor's video in BNC connector to the camera's VIDEO OUT connector.
AC 24V/DC12V model (Low Voltage Version)
This terminal accepts both AC 24 V and DC 12 V (non-polarity), with Class 2 isolated power
supply
AC 85V~265V model
The camera is equipped with a wide-ranging power supply. The unit can accept an AC power
source input from 85 VAC to 265 VAC
Note: Power is now being supplied to the camera, and the power LED illuminates. If the LED is
not illuminated, check the terminal block connections and power source.
3 A
DDITIONAL
Back Focus To adjust the lens use the included screwdriver, turn the back focus thumbwheel
screw counterclockwise (unlock) so that the back focus thumbwheel turns. (See Figure 1.). Adjust
the lens' focal position by turning the back focus thumbwheel to achieve the sharpest image.
After adjustment use the screwdriver to lock the thumbwheel screw
3.1 DD L
EVEL
When the lens mode switch is set to DD, you can set the lens iris level adjustment to ensure the
correct exposure depending on the camera's position and the lighting levels. (See Figure 2.)
S (D /N
WITCH AY IGHT ONLY
Power LED
A
DJUSTMENTS
( DC-
FOR TYPE LENSES
Installation Instructions
)
)
To local
or test
monitor
To
monitor
9