Install The Protective Covers; Communication Adapter And Electromagnetic Interference Shield Replacement; Shield Replacement; Remove The Communication Adapter And Electromagnetic - Allen-Bradley PowerFlex DC Hardware Service Manual

Chapter 3 Frame A Field Controller Part Replacement Procedures
Communication Adapter and
Electromagnetic

Interference Shield

Replacement
38
9. Disconnect the HIM communication cable from the connector on the
upper right corner of the control board and set the cover aside.

Install the Protective Covers

Install the protective covers in reverse order of removal.
ATTENTION: Risk of electric shock exists when power is applied to the power
terminals of the device. The power terminal cover and protective covers must
be replaced before you apply power to the device.

Remove the Communication Adapter and Electromagnetic

Interference Shield
1. Read the General Safety Precautions on page 10.
2. Remove power from the device (see page 33).
3. Remove the protective covers (see page 36).
Rockwell Automation Publication 23PFC-TG001A-EN-P - March 2018
=
9