Cloning V-Scanner Data - Radio Shack PRO-2096 User Manual

Digital trunking mobile/base scanner
Table of Contents

Advertisement

Beyond the Basics
CLONE MODE Incorrect Model appears if the scanner receives
data from a scanner other than a PRO-2096 and PRO-96.
This scanner can send/receive the data to or from a PRO-96
scanner. Only the Light (PRO-96) and Dimmer (PRO-2096)
settings are not transferred, they are set to default.
1. Turn on both scanners.
2. Connect the cable to each scanner's PC/IF jack. *CLONE
MODE* UP to send, Remove Cable to Exit appears on the display.
3. Press
e or d
appears on the display.
4. Press 1 to send the data to the other unit or press any
other key to cancel the operation.
5. The scanner sends the data. Do not disconnect the cable
or interrupt power to either scanner while transferring
data.
6. To exit clone mode, remove the cable.

cloning v-scanner data

Your scanner supports cloning of both working memory and
V-Scanner memory to and from other PRO-2096 and PRO-96
scanners or PC application software. This section describes
the process of cloning V-Scanner memory between two
radios.
Two types of V-Scanner memory clone are supported. Full
Clone transfers all V-Scanner folders from one PRO-2096
(the "source" radio) to a second PRO-2096 or PRO-96 (the
"destination" radio). Selective Clone transfers selected V-
Scanner folders from a "local" controlling radio to a "remote"
slave radio.
The Full Clone feature should be used with caution – it
Caution
Caution
overwrites all V-Scanner memory in the destination radio
with the contents of the V-Scanner memory in the source
. Confi rm send data? 1=YES Press other key for NO.
46

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

20-496

Table of Contents