Control Panel Operations; Lcd Display Screens; Initial Display Screen After System Initialization And Panel Revision - Hochiki HCA-2 Installation And Operation Manual

D51, D53, D57 Amber

4. Control Panel Operations

All non-programming operations and system behaviors are described in this section. See section 5 for
initial setup and control panel programming.
The HCA series control panel has 15 keys as shown in the diagram below that are used to operate and
program the panel. Some of the keys have additional functions, which become active depending on the
menu screen being displayed at the time.
Important Note: If the system is left idle in a menu without any activity for 5 minutes, the system
will automatically exit the menu.

4.1 LCD Display Screens

All status and operations display screens for the HCA panel are described below.

4.1.1 Initial Display Screen after System Initialization and Panel Revision

The HCA control panel will only take a few seconds to initialize after the system is powered on. The first
screen to be displayed will be the panel software revision which is displayed for about 10 seconds before
the panel will display the system status idle screen. The software revision can also be displayed at any
time by pressing the ACK key twice when the panel is idle. Pressing the ESC key with the software revision
screen active will bring the panel back to the system status idle screen.
Ver X.YY
Date: 12/06/2012
HCA Series Installation Manual
These LEDs are lit when the corresponding programmable relays are
activated.
1 2
abc
NAMES
4
5
ghi
jkl
No
7 8
pqrs tuv
0
*
Esc
Next Enter
Figure 4 - HCA Control Panel Keypad
The X is the version number and the YY is the revision number.
Page 25 of 58
3
RESET
def
Backward
6
mno
Silence
Yes
9
wxyz
Ack
#
Forward
V2.15