NETGEAR MP115 User Manual page 33

Average Antenna Gain
Antenna Yield
Antenna Diversity
Typical Transmit Power
Minimum Transmit Power
Receiver Sensitivity at 11Mbps
Receiver Sensitivity at 1Mbps
Maximum Receive Signal
Current Consumption at Power Save Mode
Audio Out
Dolby
Audio Maximum Output
Signal-to-Noise
THD+N
Crosstalk
Frequency Response
DAC Resolution
Video Out
S-Video Out
YPbPr Video Out
SCART Video Out
Video Output Signals
S-Video Cable
RCA Video Cable
RCA Audio Cable
Reset Switch
USB Port
2BDF0-020017 REV.00
>0dBi, when antenna integrated to the unit
>50%, when antenna integrated to the unit
Want
17dBm at 8% PER, at the antenna port with 802.11g/b data
transmission
14dBm at 8% PER, at the antenna port with 802.11g/b data
transmission
≤82dBm at 8% PER, at the antenna port
≤90dBm at 8% PER, at the antenna port
>+10dBm at 8% PER, at the antenna port
<80mA
Must, RCA (L, R) stereo; Fixed output
Digital 5.1
1.8Vpp@30mA max load, 1Vrms, 24-bit, 96KHz DAC
85dB
-78dB, A weighted
-66dB@1KHz
20Hz~20KHz ±1dB
16 bits
Composite Video RCA (Yellow)
S-Video S mini-DIN (4-pin female)
Component Video RCAx3 (Red/Green/Blue)
Composite Video SCART (21-pin male)
Stuffing option, 1.5m S-Video cable (DIN 4-pin female-to-
DIN 4-pin female that plug its cable connector into the DIN
jack marked "S-Video" on the rear panel of Digital Media
Player
1.5m video cable (RCA-to-RCA that the RCA connector
colored Yellow)
• The cable connector colored Yellow must be connected to
the RCA jack marked with the letter "Composite Video" on
the rear panel of Digital Media Player
1.5m audio cable (RCA-to-RCAx2 that the RCA connectors
colored red/white, 2 wires)
• The connector colored Red must be connected to the RCA
jack marked with the letter "Audio Out/R" on the rear
panel of Digital Media Player
• The connector colored White must be connected to the
RCA jack marked with the letter "Audio Out/L" on the
rear panel of Digital Media Player
• Push once: soft reset
• Push & hold: returns unit to factory default configure
Single USB 1.1 host port that will used as Manufactory Tool.
Page 33 of 36