Product Description; Important Information On Use; Declaration Of Conformity; Scope Of Delivery - Bosch CS 200 Installation Instructions For Installers

4 | Product Description

▶ Due to the additional functions, e.g. DHW heating or pump
anti-seizure protection, the system should always be left
on.
▶ Correct any faults immediately.
2 Product Description
2.1 Product description
• The CS 200 must be used in conjunction with the
MS 200 to control a Solar heating system, in certain
cases an MS 100 may also be combined.
• After operating for 90 minutes, the solar controller has a
power reserve of at least 8 hours. If the power failure lasts
longer than the power reserve, the time and date will be
deleted. All other settings are saved.
• The functional scope and thus the menu structure of the
solar controller are determined by the structure of the
system. These instructions describe the maximum
functional scope of the equipment. Your attention is drawn
to the importance of the system structure in the relevant
places. The adjustment ranges and default settings may
differ from the information in these instructions.
2.2

Important information on use

CAUTION:
Risk of injury through scalding!
If the DHW temperature is set to > 60 °C, discharging unmixed
domestic hot water can lead to serious scalding.
▶ Set the temperature for normal operation to < 60 °C.
▶ Do not discharge domestic hot water unmixed.
▶ Install a mixer.
• Only products from Bosch may be used within the BUS
system.
• The installation room must be appropriate for IP20 rating.
2.3

Declaration of Conformity

The design and operation of this product comply
with European Directives and the supplementary
national requirements. Conformity has been
demonstrated by the CE marking .
You can ask for a copy of the Declaration of Conformity for this
product. Please refer to the contact address on the back cover
of these instructions.
6720850722 (2015/06)
2.4

Scope of delivery

1
Fig. 1 Scope of delivery
[1] Wall-mounting plate
[2] Solar controller
[3] Installation material
[4] Technical documentation
2.5

Technical specifications

auto
man
fav
123
Fig. 2 Dimensions in mm
Scope of delivery
Dimensions
Nominal voltage
2
3
4
0010005428-001
menu
info
0010005429-001
 Chapter 2.4, page 4
150 × 90 × 25 mm
( Fig. 2)
10 - 24 V DC
25
32
CS 200