Titan SF2842 Safety And Operating Manual page 11

3. To remove or install battery pack
Locate latches on side of battery pack and
depress both sides to release battery pack from
your saw. Remove battery pack from your saw.
After recharge insert the battery pack into saw's
battery port. A simple push and slight pressure
will be sufficient.
4. Lock off switch
Your switch is locked off to prevent accidental
starting. Depress lock off button (2) then on/off
switch (1) and release lock off button (2). Your
switch is now on. To switch off just release the
on/off switch.
The speed of the blade can be adjusted by the
pressure you apply to the switch. To increase
the speed, apply more pressure to the switch.
To decrease the speed, apply less pressure. (See
fig3)
5. Hand grip areas
Always hold your saw firmly with both hands
when operating (See fig4).
6. Tool-less blade fitting
Press the bland clamp button , insert the blade
shank into the blade clamp through the blade
guard until it stops. Ensure the small hole in the
blade is on the pin in the clamp then release the
button (4) (See fig5). Pull up on blade to make
sure that it is locked in. To remove a blade, carry
out these instructions in reverse order.
Warning: Blade teeth are very sharp. If
blade has been used recently it will be
hot. Wear Gloves. For best cutting results
ensure you use a saw blade suited to the
material and cut quality you need.
It is possible to make cuts extremely close to
floors, walls and other difficult areas. Insert the
blade shank into the blade clamp with the blade
teeth facing up (opposite to normal working
position).
This will make cuts closer to the work surface.
7. Pivoting foot
The pivoting blade foot must be held firmly
against the material being cut to reduce saw
vibration, blade jumping and blade breakage.
To adjust, hold saw firmly and pivot foot plate to
desired position. (See fig6)
18V RECIPROCATING SAW
SF2842 CSR18P-M-060425.indd 11
1 2
Fig 3
Fig 4
2
Fig 5
Fig 6
SF2842
4
2006-5-25 11:18:31