NETGEAR DG834N Reference Manual page 89

DG834N RangeMax NEXT Wireless ADSL2+ Modem Router Reference Manual
Internet
192.168.0.1
Figure 5-10
To set up a point-to-point bridge configuration (shown in
1. Configure the DG834N modem router (AP 1) on LAN Segment 1 in point-to-point bridge
mode.
2. Configure the other access point (AP 2) on LAN Segment 2 in point-to-point bridge mode.
The DG834N modem router must have AP 2's MAC address in its Remote MAC Address
field, and AP 2 must have the DG834N's MAC address in its Remote MAC Address field.
3. Configure both APs and verify that both APs are using he same SSID, channel, authentication
mode, if any, and security settings if security is in use.
4. Disable the DHCP server on AP2. AP1 will then be the DHCP server.
5. Verify connectivity across LAN Segment 1 and LAN Segment 2.
A computer on either LAN segment should be able to connect to the Internet or share files and
printers of any other PCs or servers connected to LAN Segment 1 or LAN Segment 2.
Advanced Configuration
Both access points (APs) are in
point-to-point bridge mode.
AP 1 (DG834N modem router)
LAN Segment 1
v1.0, April 2008
PC's
LAN Segment 2
Figure 5-10):
AP 2
Switch or hub
PC's
5-15