Table of Contents
Advertisement
49-2570.fm Page 30 Wednesday, August 18, 1999 3:59 PM
Problem
You do not hear a chime from
the console when you press
to install a remote.
ARM
You do not hear a chime from
the console when you press
to install a door/window
TEST
sensor transmitter or motion
detector.
The BATTERY LOW indicator
on the console is on.
You lose your remote control.
The system arms or disarms
by itself.
The red indicator on the hand-
held remote control stays on
during installation.
30
Solution
Check if you can arm the system when
on the console is set to
RUN 2
the remote control is already installed and no further ac-
tion is necessary. If not:
1. Set
INSTALL/RUN 1/RUN 2
.
INSTALL
2. Press
(located beneath the label on the
CODE
remote control) with a pencil, then press
With
INSTALL/RUN 1/RUN 2
check that the console chimes when you press
the sensor transmitter or motion detector. If it does, the
sensor transmitter or motion detector is already installed
and no further action is necessary. If not:
1. Set
INSTALL/RUN 1/RUN 2
.
INSTALL
2. Press
on the motion detector with a pencil or
CODE
remove then reinstall the batteries in the sensor
transmitter. Then press
Note: If the sensor transmitter/motion detector is already
installed, it is installed again into the next available zone.
Replace the console's battery.
Purchase a replacement remote control (Cat. No. 49-
2591T or 49-2591), and then completely re-install your
system to prevent someone else from using the lost re-
mote control.
A neighbor might have a compatible system. Re-install
the remotes.
Press the button located beneath the label with a pencil
and then press
. If it still stays on, remove the bat-
ARM
tery, wait a few seconds, then replace the battery. Press
the button and then
ARM
INSTALL/RUN 1/
or
. If you can,
RUN 1
RUN 2
on the console to
again.
ARM
on the console set to
RUN 2
TEST
on the console to
again.
TEST
again.
,
on
Advertisement
Table of Contents
