Radio Shack CENTRAL 49-2570 Owner's Manual page 29

49-2570.fm Page 29 Wednesday, August 18, 1999 3:59 PM
Problem
You cannot turn lights on or off
from the
LIGHT ON
buttons on the remote.
OFF
You open a door or window
and the alarm does not trip.
Appliances turn off during an
alarm.
• Make sure you set the house and unit code on the
or module(s) to the same letter and number as you
LIGHT
selected for the console.
• Be sure the light you are trying to control is plugged
in and has its on/off switch in the on position, and
that its bulb is good.
• Plug the module into another outlet on the same
electrical circuit as the console.
• Check that the battery indicator on the remote con-
trol comes on when you press a button. Replace the
battery and re-initialize the remote control, if neces-
sary.
• Make sure
INSTALL
• Check to see if the system is armed.
• Be sure
to
RUN1
• Press
TEST
and see if the alarm trips. If the alarm does not trip,
see if the sensor transmitter indicator comes on
when you press
come on, replace the battery and re-initialize the
sensor transmitter, if necessary.
The system flashes lights by repetitively transmitting the
signal to turn all units on or all units off. Therefore, any
appliances connected to appliance modules which were
on at the time of the alarm, turn off and stay off.
If you do not want this to happen, set the appliance mod-
ule(s) to a different house code than you selected for the
console.
Solution
INSTALL/RUN 1/RUN 2
.
on the console is set
INSTALL/RUN 1/RUN 2
or .
RUN 2
on the door/window sensor transmitter
. If the indicator does not
TEST
is not set to
29