Table of Contents
Advertisement
SWITCHING POWER ON/ OFF
Press [ ] to switch the transceiver ON.
Press [ ] again to switch the transceiver OFF.
ADJUSTING THE VOLUME
Press the key programmed as [Volume Up] to increase the volume. Press the
key programmed as [Volume Down] to decrease the volume.
SELECTING A ZONE AND CHANNEL
Select the desired zone and channel using the keys programmed as [Zone Up]/
[Zone Down] and [Channel Up]/ [Channel Down].
•
"G1" (Zone 1)/ "16" (Channel 16) appears on the display.
TRANSMITTING
1 Select the desired zone and channel.
2 Press the key programmed as [Monitor] or [Squelch Off] to check whether or
not the channel is free.
•
If the channel is busy, wait until it becomes free.
•
For best sound quality at the receiving station, hold the microphone approximately
1.5 inches (3 cm to 4 cm) from your mouth.
RECEIVING
Select the desired zone and channel. If signaling has been programmed on the
selected channel, you will hear a call only if the received signal matches your
transceiver settings.
Receiving Group Calls
When you receive a group call and the received group ID matches the ID set up
on your transceiver, you can hear the caller's voice.
Receiving Individual Calls
When you receive an individual call, a ringing tone will sound and the caller's ID
will appear on the display. To respond to the call, press and hold the PTT switch
and speak into the transceiver as you would during a normal transmission.
BASIC OPERATION
11
Advertisement
Table of Contents
