Epson Stylus Color 880 Setup Manual page 5

Follow the instructions in the appropriate section below to install the printer
software. If you are DOS user, see "Printing with DOS" in the Daily Use
guide.
For Windows 98, 95, 2000, and NT 4.0 users
Windows 98, 95, 2000, and NT 4.0 users must first install the printer
software, and then, if you are connecting via the USB port, check to ensure
that the USB cable is correctly installed. If you are connecting via the parallel
port, proceed to section
Installing the software
Follow the steps below to install the printer software.
1. Make sure that your printer is off.
2. Turn on your computer and start Windows. If the New Hardware
Found screen or any other Wizard appears, click Cancel.
3. Insert the printer software CD that is shipped with your printer in the
CD-ROM drive. The Installer dialog box opens. (For floppy disk users,
insert the disk in the disk drive and double-click the My Computer
icon, the floppy disk drive icon, and then Setup.exe.)
4. Select Install Printer Driver/Utility
and click
dialog box that appears to start the
printer software installation.
Note:
It is possible to install the Reference
Guide on your hard drive from the
Installer dialog box, as shown at the
right. To install the guide, select Online
Guide and then click
Install Reference Guide and follow
the on-screen instructions. When the
installation is complete, an ESC880
Guide icon appears in the EPSON folder. Double-click the icon to open the
guide.
5. Follow the on-screen instructions to turn on your printer.
For Windows 98 users, the printer port configuration starts
automatically.
For printers connected via USB cable, the USB device driver installation
starts automatically at this point. A message will appear asking you to
restart your computer. Follow this instruction.
Copyright© 2000 by SEIKO EPSON CORPORATION,
Nagano, Japan.
after installing the software.
. Then, click OK in the
. Then, click
Printed in Japan.xx-xx