Periodic Service Schedule - Club Car Villager 2000 Owner's Manual

In addition, check the items listed below:
• Tires: Visually inspect for wear, damage and proper inflation.
• Forward/Reverse switch: Check for proper operation. See Controls, Page 12.

PERIODIC SERVICE SCHEDULE

WARNING
• SERVICE, REPAIRS, AND ADJUSTMENTS MUST BE MADE PER INSTRUCTIONS IN THE 2000
TRANSPORTATION MAINTENANCE & SERVICE MANUAL.
NOTE
• IF THE VEHICLE IS CONSTANTLY SUBJECTED TO HEAVY USE OR SEVERE OPERATING
CONDITIONS, THE PREVENTATIVE MAINTENANCE PROCEDURES SHOULD BE PERFORMED
MORE OFTEN THAN RECOMMENDED IN THE SERVICE AND LUBRICATION SCHEDULES.
• BOTH THE PERIODIC SERVICE SCHEDULE AND PERIODIC LUBRICATION SCHEDULE MUST
BE FOLLOWED TO KEEP VEHICLE IN OPTIMUM OPERATING CONDITION.
PERIODIC SERVICE SCHEDULE
REGULAR INTERVAL
Daily Service by Owner
Weekly Service by Owner
Monthly Service by Owner
or Trained Technician
Semiannual Service by
Trained Technician Only
(Every 50 hours of
operation)
Annual Service by Trained
Technician Only (Every 100
hours of operation)
20 2000 Transportation Electric Vehicle Owner's Manual
SERVICE
Batteries
Batteries
Batteries
Tires
Wiper Switch (Four-Passenger Villager
only)
General Vehicle
Brake System
Electrical Wiring and connections
Forward and Reverse Switch
Front Wheel Alignment and Camber
Batteries
Periodic Service Schedule
Charge batteries (after each use only).
Check electrolyte level. Add water as necessary per
Transportation Maintenance and Service Manual.
Wash battery tops and clean terminals with baking
soda/water solution. Dispose of waste water properly.
Check air pressure and adjust as necessary. See
Vehicle Capacities Chart on Page 22.
Check for cracks or other damage; make sure switch
is securely fastened to frame. Check movable contact
for correct operation.
Wash battery compartment and underside of vehicle.
Dispose of waste water properly.
Check brake shoes; replace if necessary. See
Transportation Maintenance and Service Manual.
Lubricate brake slides per Lubrication Schedule. See
Transportation Maintenance and Service Manual.
Check brake cables for damage; replace as required.
Check for tightness and damage.
Check condition of contacts and wire connections;
Make sure connections are tight.
Check and adjust as required. See Transportation
Maintenance & Service Manual, Section 7.
If batteries are not performing as expected, refer to
the PowerDrive System 48 Maintenance & Service
Supplement, Section 13–Batteries.