Table of Contents
Advertisement
www.freeservicemanuals.info
Specifications
Power Output
Minimum sine wave continuous average power output per
channel, all channels operating is:
200 watts into a 4 ohm load
120 watts into a 8 ohm load
Rated Power Band
20Hz to 20,000Hz
Total Harmonic Distortion
Maximum Total Harmonic Distortion at any power
level from 250 milliwatts to rated power output is:
0.005% for 4 or 8 ohm loads
Dynamic Headroom
1.6dB
Frequency Response
+0, -0.25dB from 20Hz to 20,000Hz
+0, -3dB from 10Hz to 100,000Hz
Sensitivity
1.0 Volt
A-Weighted Signal To Noise Ratio
92dB (113dB below rated output)
Intermodulation Distortion
Maximum Intermodulation Distortion if instanta-
neous peak output per channel does not exceed
twice the rated output, for any combination of fre-
quencies from 20Hz to 20,000Hz, with all channels
operating is:
0.005% for 4 or 8 ohm loads
Input Impedance
10,000 ohms
Wide Band Damping Factor
100 at 4 ohms
200 at 8 ohms
14
Power Requirements
100 Volts, 50/60Hz at 13.2 amps
110 Volts, 50/60Hz at 12.0 amps
120 Volts, 50/60Hz at 11.0 amps
220 Volts, 50/60Hz at 6.0 amps
230 Volts, 50/60Hz at 6.0 amps
240 Volts, 50/60Hz at 6.0 amps
Note: Refer to the rear panel of the MC206 for the correct
voltage.
Dimensions
Front Panel: 17-1/2 inches (44.45cm) wide, 7-1/8 inches
(18.10cm) high. Depth behind front mounting panel is 18
inches (45.72cm). Clearance required in front of the Front
Panel is 1 inch (2.54cm) for knobs.
Weight
57 pounds (25.9 kg) net, 76 pounds (34.5 kg) in shipping
carton
Digitized in Heiloo Netherland
5/10/2017
Specifications
Advertisement
Table of Contents
