Caller Id Operation; Reviewing Caller Id Records; Storing A Caller Id Record To Memory - Radio Shack ET-1111 Owner's Manual

900 mhz digital spread spectrum cordless telephone with caller id/call waiting id
Table of Contents

Advertisement

43-1111.fm Page 18 Tuesday, June 29, 1999 3:38 PM

CALLER ID OPERATION

If you subscribe to Caller ID service from
your phone company, the phone compa-
ny sends information about the call, as
well as the time and date, between the
first and second rings of every call you
receive.
The ET-1111 displays this information
when it receives a call, and it stores up
to 50 Caller ID records for later review. It
also shows if caller information is un-
available or if the name and number
were blocked by the caller (see "Caller
ID Messages" on Page 20).
If you subscribe to Call Waiting with
Caller ID, you will hear a tone through
the handset when a call comes in, then
the Caller ID record appears. If you want
to answer the incoming call, press
. To resume the previous phone
FLASH
conversation, press
FLASH
If the ET-1111's Caller ID memory be-
comes full, any new call replaces the
oldest call's record.
REVIEWING CALLER ID
RECORDS
To review the Caller ID records, lift the
handset and press
CALL ID
of new Caller ID records, if any, and the
total number of records appears.
18
Note: If the handset is faceup on the
base, it shows the number of Caller ID
records, so you can see if you have new
records to review.
Repeatedly press
the Caller ID records from the newest to
the oldest, or
the records. To scroll quickly through the
records, hold down
When you scroll past the last record,
End
first record, the record totals appear.
The top line of each record shows the
date, time and the number of calls from
that number. The second line shows the
caller's name, and the third line shows
the caller's phone number.
again.
STORING A CALLER ID
RECORD TO MEMORY
Follow these steps to store the name
and number from a Caller ID record into
a memory location.
1. Recall the Caller ID record you want
to store, then press
Location
. The number
2. Choose a memory location (1–0) by
pressing a number or by repeatedly
pressing
LECT
If the selected location is empty, the
phone beeps to confirm that it
stored the number, then the Caller
ID record appears.
to scroll through
to scroll back through
or
appears. When you scroll past the
MEM
appears.
or
, then press
.
.
.
Select
SE-

Advertisement

Table of Contents
loading

Table of Contents